EDF Ducted Fan Wemotec Mini Fan evo 70mm (9 blades) + HET 1W-45

MFE-1W45

New product

Wemotec

Modern high efficiency multi bladed fan unit. The fan unit comes completely mounted with a HET 1W45 motor.  This Pack is precisely assembled, balanced and tested by us.

More details

This product is no longer in stock

By buying this product you can collect up to 120 points . Your cart will total 120 points that can be converted into a voucher of US $2.83 .


US $142.49

Instead of US $166.09

Accessories and other versions

Data sheet

Weight (gr): 250 gr
EDF thrust (categorization) 1-2kg, 2-3kg
Direction of Rotation (EDF Rotor) Classic Counter Clock Wize (CCW)
EDF Diameter Class (mm): 70
Blades: 9
Turbine shroud Synthetic
EDF Rotor Synthetic
Turns/min/Volt (Kv): 3000
Motor Type: In-Runner
Motor Diameter (mm): 28
Shaft diameter (mm): 4
Battery Cells: 5s - 18.5v, 6s - 22.2v

More info

EDF Ducted Fan Wemotec Mini Fan evo / HET 1W-45

Modern high efficiency multi bladed fan unit. The fan unit comes completely mounted with a HET 1W45 motor. The unit is assembled and checked at factory, precision balanced and harmonically tuned.

This Pack, composed with the EDF unit, the motor and the assembling and balancing service, is precisely set, harmonically balanced and tested by us.

This is an extremely strong, yet affordable 5s or 6s setup.
Since current can reach up to 110 A readily installed, we recommend 3.000 mAh cells 30C or better and a good 100 to 150A speed controller. Throttle management is recommended to reach a good flying time.

Set comprises

  • 1 x Mini Fan evo ducted fan unit
  • 1 x Intake Lipo
  • 1 x HET 1w45
  • 1 x Heatsink
  • PK plugs and shrink tune
  • Screws
  • English Instructions

Readings

 
5s
6s
 Voltage
 18.5 V
22.2 V
 Current
 87.0 A
110.0 A
 Power
1609 W
2442 W 
 rpm na na
 Thrust
2.0 kg
2.5 kg
 Efflux velocity    
na
na
 Efficiency
na
na
 Controller
>= 100A / LV
 >= 130 / LV 
 Rec. Battery 
 >= 3000 mAh 35c  
= 3000 mAh 35c

Readings:
  We measure with a constant voltage of 3.7 V / cell. Current and thrust are measured with a small intake lip (r=6 mm) at 21° C, 50m asl and standard pressure. Depending on battery, controller and installation you may see higher or lower figures.The controller should be chosen 20% over rated due to the long lasting load.
LV = low voltage controller up to 6s, HV = high voltage controller above 6s.
Battery should be chosen about 15/ - 1/20 of the max current for 4-3 minutes WOT. 30-40 C is appropriate.
 
 inner diameter:  69,0 mm
 outer diameter:  72,0 mm
 length of shroud:  60 mm, w/o intake lip
 weight, complete:  250 grams (opt. intake rin + 15g)
 fan swept area:  29,40 sqcm
 rotor:  9 blades, nylon (glass reinforced)  
 rec. thrust tube dia.:   56 mm diameter
 Timing ESC:  approx. 18° (6-pole motor)
 PWM:  16 kHz


Motor specifications

  • Diameter: 28 mm
  • Length: 68  mm
  • Shaft Dia.: 4 mm
  • Weight: 193 grams
  • No load current(lo): na
  • Internal resistance: na
  • KV: 3000
  • No. of poles: 6
  • Max Current: na
  • Max efficiency: na
  • Power Nominal: na
  • Advance timing : 18° Middle PWM: 16 Khz 

Mini Fan evo unit Specifications

  • Material: Nylon, ABS, Aluminium
  • Weight: approx. 57 g (with intake ring + 15g)
  • Power: 500-3.000 W
  • max rpm: 60.000
  • Rotor: 9 blades(68 mm) glass reinforced
  • Kit comprises: all components, english instruction
  • Ageom.: 29.4 qcm
  • Aeff.: 26.2 qcm
  • Thrust: 6-30 N
  • Thrust tube should be 56 mm in diameter for best performance. You can find several versions of such tubes in our shop.
  • Reviews
  • No customer reviews for the moment.

    Write a review

    EDF Ducted Fan Wemotec Mini Fan evo 70mm (9 blades) + HET 1W-45

    EDF Ducted Fan Wemotec Mini Fan evo 70mm (9 blades) + HET 1W-45

    Modern high efficiency multi bladed fan unit. The fan unit comes completely mounted with a HET 1W45 motor.  This Pack is precisely assembled, balanced and tested by us.

    30 other products in the same category:

    Customers who bought this product also bought: