Sequencer for Landing Gear RC Lander

Sequencer for Landing Gear RC Lander

This electronic switch is used to control the sequence of electric retracts (or mechanical retracts if using 2 retract servos) from your transmitter gear channel switch. It is ideally suited to 'mains' where scale realism can be added by making use of the built-in delay.

Connections

The input side is connected to the receiver gear channel.
The output side has connections for left and right gear.

The switch uses a 'jumper' to bridge the pins identified as Type 1 / Type 2. The jumper is placed on the appropriate pins to select the sequence as described below:

Jumper on pins 1 + 2

• First leg up followed by the second leg up with a 6 second delay.
• First leg down followed by the second leg down with a 6 second delay.

Jumper on pins 2 + 3

• First leg up followed by the second leg up with a 6 second delay.
• Both legs down together.

Reverse channel selection:

• The switch uses a second 'jumper' to bridge the pins identified as Gear 1 / Gear 2. The jumper is placed on the appropriate pins 1 + 2, or 2 + 3 to reverse the channel should this function not be available on the transmitter.

Specifications

• Input voltage: 4.8~8.4V
• Cable length: 18cm
• Dimensions: 52 x 19 x 5mm (LxWxH)
• Weight: 6g