Ducted Fan EDF Schubeler DS-51-AXI HDS V2015 90mm + HET 700-68-2100 motor

This combo Schübeler DS-51-AXI HDS 90mm equiped with the Typhoon HET 700-68-2100 motor generates approx 3.2Kg of thrust / 104A with 5S and 4,3kg of thrust / 135A with 6S.

The controller should be chosen 20% over rated due to the long lasting load.
LV = low voltage controller up to 6s, HV = high voltage controller above 6s.
Battery should be chosen about 15/ - 1/20 of the max current for 4-3 minutes WOT. 30-40 C is appropriate.

Note: this combo is provided assembled and balanced. You can also buy both the EDF unit and the motor separetly with us without the assembling and balancing service.

Note: The "Secure Fan Fix" system visible on some pictures is not included. Please refer to the "accessories" section on this page for the available options.

Note: Given performances have been measured with a fan equiped with an intake lip. Please refer to the "accessories" section on this page for the available options.

Specifications:

About the Thyphoon HET 700-68-2100 motor

Typhoon HET EDF 700-68-2100 Motor 39mm, recommended for 6s Lipo (5s to 7s Lipo) and suitable for any 90mm ducted fan units using 39mm motor's diameter. Recommended for 90mm HET EDF unit 9305-700, Schubeler DS 51 or equivalent from 4 to 6 blades, for 9 bladed 90mm JETFAN-90 EDF unit type and Stumax EDF type 90mm. Also suitable for any 90mm ducted fan units using 39mm motor's diameter.

Description:

• High Temperature magnets and stator wire
• 0,2mm silicon steel stator from Japan
• Hardened shaft
• CNC precision parts
• Dynamically balanced

Specifications: 

• Diameter: 39 mm 
• Length: 67,5 mm
• Shaft Dia.: 5 mm 
• Weight : 330 grams
• No load current(lo): 2.5(10v)
• Rm (Ohm) : 5.80
• KV: 2100
• Poles: 4
• Max efficiency: 85%
• Recommended advance timing: low
• Power Nominal: 1400 Watts (max: 2500 W)
• Recommended ESC from 70A (5s) to 120A (7s)
• Includes Aluminum Heat Sink and tools

Note: Use adhesive adhésive or glue to securely attach the cooling ring to the motor before running the motor. In case of use with an EDF fan unit, strong air current could blow away the colling ring. Thermal paste usage is also recommended.

WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.