NX3 EVO 2D/3D Stabilizer for plane

NX3 EVO 2D/3D Stabilizer for plane

NX3 EVO 2D/3D fixed-wing flight gyro NEW VERSION control board offers several new modes and more functionalities requested for a flight stabilizer.  The NX3 stabilizer smoothes out air turbulence, but does much more. Also includes an Emergency mode to save your models.

Features

• NX3 EVO provides four levels of flight modes: 

1. Beginner: Aileron auto-leavel . roll angle limit to ±75 degree. When the aileron stick back to center position, the aileron will keep level automatically. The elevator will be control by youself, there is no auto-level function. But will provide obvious assist,the pictch have attitude locking function. Beginner mode is for very beginner player.Also can be used for short-range FPV.
2. Practice: Attitude locking for roll,pitch,yaw.restriction on roll and pitch speed. Practice mode do not have auto-level and angle limit function. Practice mode is for practise flying.
3. Promotion: Attitude locking for roll,pitch,yaw. Promotion mode is very likely from practice mode.It provide aititude locking function.Compare to practice mode,promotion mode supply more sensitive sense of control .
4. Expert: Simple Gyro correction.The best control sense. It supply a simple Gyro correction and anti-wind function.

• Four wing types: Single / Dual aileron / Delta wing / V-tail.
• Separate gain adjustment for each axis
• Single/Separate Dual ailerons recognition capability.
• Remote master gain adjustment during flight.
• Including emergency mode, One-key auto safety.
• Automatic stick centering
• Automatic level offset, self-balance.
• 3D AVCS flight, Attitude locking.
• Provide Y-wiring for aileron
   

Specifications

• Voltage range: DC 4.5 – 6V
• Response Frequency: 100Hz
• Operating Temperature: 0-50°C
• Dimension: 43x28x15mm
• Weight: 11g

Packing List

• NX3evo Flight Controller Board
• NX3 evo Manual  (english)
• Servo Wire set
• Double-sided Tape
• Screwdriver*