> >>>Ducted Fan EDF JETFAN-130 PRO Ejets + TFL SSS 56104-550
Ducted Fan EDF JETFAN-120 PRO Ejets + HET 800-68-685 View larger
Previous Next

Ducted Fan EDF JETFAN-130 PRO Ejets + TFL SSS 56104-550

EJT-JF130P-SSS56104-550

New product

Ejets Jetfan

Combo 130mm / 11 blades / 550Kv (inrunner) / 1480g
> 14S (54.5V): 128A / 10.55kg / 6975W

More details

This product is no longer in stock

By buying this product you can collect up to 1031 points . Your cart will total 1031 points that can be converted into a voucher of US $24.33 .


US $1,217.37

Accessories and other versions

Must have accessories and options

INTAKE LIP:

Carbon Intake Ring for Ejets JETFAN-130 PRO Carbon Intake Ring for Ejets JETFAN-130 PRO
US $58.90

BRUSHLESS CONTROLLER:

JP Hobby 200A HV ESC 6-16S OPTO JP Hobby 200A HV ESC 6-16S OPTO
US $392.35
Jeti / Hacker Master SPIN 200 Pro 6-14S OPTO Jeti / Hacker Master SPIN 200 Pro 6-14S OPTO
US $426.77

Data sheet

Length (mm): 100 mm
Weight (gr): 1480 gr
EDF thrust (categorization) 8-10kg, 10-12kg
Direction of Rotation (EDF Rotor) Classic Counter Clock Wize (CCW)
EDF Diameter Class (mm): 130
Blades: 10
Turbine shroud Carbon
EDF Rotor Synthetic
Turns/min/Volt (Kv): 550
Motor Type: In-Runner
Motor Diameter (mm): 56
Shaft diameter (mm): 10
Battery Cells: 14s - 51.8v
Connection: PK 8mm

More info

Ducted Fan EDF JETFAN-130 PRO Ejets + TFL SSS 56104-550

 Characteristics / LIPO 14S
 Voltage 54.5v
 Current 128 A
 Power 6975 W
 Thrust 10.55 kg 
 Controller >=160A / HV
 Recommended battery (measured with Hacker 5800mAh)   >=4500mAh 35C 

The controller should be chosen 20% over rated due to the long lasting load.
LV = low voltage controller up to 6s, HV = high voltage controller above 6s.
Battery should be chosen about 15/ - 1/20 of the max current for 4-3 minutes WOT. 30-40 C is appropriate.
Note: this combo is provided assembled and balanced. You can also buy both the EDF unit and the motor separetly with us without the assembling and balancing service.


About the Ejets JETFAN 120 PRO EDF Unit

New ducted fan unit JETFAN-130 PRO for jet models of the 130 mm class, as well as the 90s -100er turbines class! The new JETFAN-130 PRO has been developed for large jet models up to 17.5 kilo weight.

Description

The basic design was matched to 56mm engines, which bring up to 13.5 kilos thrust under test bench conditions at 14s. For higher thrusts up to 15.5 kilos, 15-16s drives are conceivable, the JETFAN-130 PRO can do it but this use requires precise and moderate power management and is not covered by the warranty.  The customers' requirement for a little more "audible punch and turbine noise" is achieved by more blades and lowering of the speed. Thus, we have again a distinctive sound, and could suppress the unpleasant high frequencies.

Technical Description

  • Length: 100mm
  • Rotor diam.: 129mm
  • Indisde diam.: 131mm
  • Outside diam.: 133mm
  • For: 12-16s Lipo (14s maximum to be covered by the warranty).
  • Input power: -
  • Max RPM: -
  • max static thrust: approx 15kg (16s) (14s maximum to be covered by the warranty).
  • Max exhaust speed range: 315km/h (10kg) to 390km/h (15kg)
  • Rotor: 10 blade
  • Weight: 380gr
  • Motor housing: accepts 56mm DIA motors
  • Shaft adaptor: accepts a 10mm DIA motor shaft
  • Delivered without motor

About the TFL SSS 56104-550 motor

Specifications

  • Diameter: 56 mm 
  • Length: 104 mm
  • Shaft Dia.: 10 mm
  • Shaft length: 22mm
  • Screws: M4
  • Weight: 1100 gr
  • Internal resistance: tbc
  • KV: 550
  • No load current (lo): 2.6
  • Max Amps : 150A
  • Max voltage : 91V
  • Max power : 14000W
  • Max RPM : 50 000
  • Max efficiency: tbc
  • Poles : 6
  • Recommended advance timing : tbc
 
WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.
Warning: Screws that are too long can short out the windings resulting in a cooked motor, this is not covered by warranty

  • Reviews

    • No customer reviews for the moment.

    Write a review

    Ducted Fan EDF JETFAN-130 PRO Ejets + TFL SSS 56104-550

    Ducted Fan EDF JETFAN-130 PRO Ejets + TFL SSS 56104-550

    Combo 130mm / 11 blades / 550Kv (inrunner) / 1480g
    > 14S (54.5V): 128A / 10.55kg / 6975W

    30 other products in the same category:

    My account

    Information

    © Copyright 2025 TURBINES RC. All Rights Reserved.

    Newsletter

    Follow us

    This website uses its own and third-party cookies to improve our services and show you advertising related to your preferences by analyzing your browsing habits. To give your consent to its use, press the Accept button.

    More information Customize cookies

    Cookie preferences
    Consent

    Functional cookies
    No
    Yes
    Functional cookies are strictly necessary to provide the services of the shop, as well as for its proper functioning, so it is not possible to refuse their use. They allow the user to browse through our website and use the different options or services that exist on it.
    Cookie Provider Purpose Expiry
    PHP_SESSID www.turbines-rc.com The PHPSESSID cookie is native to PHP and allows websites to store serialised status data. On the website it is used to establish a user session and to pass state data through a temporary cookie, which is commonly known as a session cookie. These Cookies will only remain on your computer until you close your browser. Session
    PrestaShop-# www.turbines-rc.com This is a cookie used by Prestashop to store information and keep the user's session open. It stores information such as currency, language, customer ID, among other data necessary for the proper functioning of the shop. 480 hours
    Analytics cookies
    No
    Yes
    Collect information about the user's browsing experience in the shop, usually anonymously, although sometimes they also allow the user to be uniquely and unequivocally identified in order to obtain reports on the user's interests in the products or services offered by the shop.
    Cookie Provider Purpose Expiry
    _ga Google Registers a unique ID that is used to generate statistical data on how the visitor uses the website. 2 years
    _gat Google Used by Google Analytics to throttle request rate 1 day
    _gat_gtag_UA_# Google Used to throttle request rate. 1 minute
    _gd# Google This is a Google Analytics Session cookie used to generate statistical data on how you use the website which is removed when you quit your browser. Session
    _gid Google Registers a unique ID that is used to generate statistical data on how the visitor uses the website. 1 day