Pichler Motor Boost 50 610Kv + XQ Controller 70A + XQ Programming card Set

PCH-C3173

New product

Turbines RC

Combo composed of a Boost 50 610KV brushless motor, a 70A brushless controller and a programming card.

More details

Available

By buying this product you can collect up to 149 points . Your cart will total 149 points that can be converted into a voucher of US $3.52 .


US $176.02

Data sheet

Weight (gr): 343
Power System Brushless Boost 50
No. of Magnet Poles: 14
Turns/min/Volt (Kv): 610 KV
Motor Type: Out-Runner
Motor Diameter (mm): 50
Shaft diameter (mm): 6
Electronic Speed Control 70A
Battery Cells: 2s - 7,4v, 3s - 11.1v, 4s - 14.8v

More info

Pichler Motor Boost 50 610Kv + XQ Controller 70A + XQ Programming card Set

Combo composed of a Boost 50 610KV brushless motor, a 70A brushless controller and a programming card. The BOOST motor series is the result of more than 15 years of experience and high quality.

Features

  • Perfect ventilation thanks to the open housing design
  • Use of better materials
  • High temperature resistant neodymium magnets
  • Very high quality ball bearings
  • Axe long 180 mm disponible comme accessoire
  • For 3D aerobatic models up to 3000g
  • For aerobatic models up to 3500g
  • For trainer models up to 4000g
  • For glider models up to 4500g

Specification

  • Motor Diameter: 50mm
  • Motor Length: 46mm
  • Shaft Diameter: 6mm
  • KV: 610
  • Operating Voltage: 6/16V
  • Poles: 14
  • Max efficiency: 85%
  • Peak current: 55A (30s)
  • Power: nc
  • Recommanded LiPo battery: 3S-4S
  • ESC: brushless 70A Bec 5V / 4A (max. 70A)
  • Combo Weight : 343g

Content

  • 1x brushless BOOST 50 motor
  • 1x brushless XQ-70 ESC
  • 1x Programming Card
  • 1x Aluminium mounting cross
  • 1x Propeller adapter for front bulkhead / rear bulkhead assembly
  • Mounting screws
  • German and English instructions manual (downloadable below)
WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.
 
 
  • Reviews
  • No customer reviews for the moment.

    Write a review

    Pichler Motor Boost 50 610Kv + XQ Controller 70A + XQ Programming card Set

    Pichler Motor Boost 50 610Kv + XQ Controller 70A + XQ Programming card Set

    Combo composed of a Boost 50 610KV brushless motor, a 70A brushless controller and a programming card.

    25 other products in the same category: