Typhoon HET EDF 700-83 Motor 39mm 1445Kv (5mm shaft)

Typhoon HET EDF 700-83 Motor 39mm 1445Kv (5mm shaft)

Typhoon HET 700-83 series brushless motors are designed for 90 and 120 mm fan units that demand the ultimate in performance.  The 700-83 series offers high power output for large edf fan units.  The 700 series motors will work with the HET 120mm fan units, the HET 9305-700 90mm fan unitsn the Ejets Jetfan 80 et 90 units and  the Schubeler DS-94 HDT.  The fan comes with a heat sink and tools for mounting. This motor will not work with WeMoTec Midi Fan or the HET 9305 fan unit.

Description

• High Temperature magnets and stator wire
• 0,2mm silicon steel stator from Japan
• Hardened shaft
• CNC precision parts
• Dynamically balanced

Specification

Note: This motor will not work with WeMoTec Midi Fan or the HET 9305 fan unit (work with HET 9305-700 fan unit).

Note: Use adhesive adhésive or glue to securely attach the cooling ring to the motor before running the motor. In case of use with an EDF fan unit, strong air current could blow away the colling ring. Thermal paste usage is also recommended.

WARNING: Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.

Warning: Screws that are too long can short out the windings resulting in a cooked motor, this is not covered by warranty